Panasonic GM1 - Page 3

Introduction
Thank you for purchasing a Panasonic product. Before you use the product, please carefully
read through the user
’s manual, and understand it in detail to use the product properly.
Types of Manual
● There are different types of manuals for the GM1 series. Refer to the appropriate manual
according to your need.
These manuals can be downloaded from our website: https://industrial.panasonic.com/ac/e/
motor/motion-controller/mc/gm1/index.jsp.
Manuals for GM1 series
Manual name Manual code Description
GM1 Controller RTEX User's Manual
(Setup)
WUME-
GM1R
TXSU
Explains wiring between the GM1 and its
peripheral devices, installation method, and
operation check method.
GM1 Controller RTEX User's Manual
(Operation)
WUME-
GM1R
TXOP
Explains how to use GM Programmer and
PANATERM Lite for GM, set up each function,
create projects, and perform other operations.
GM1 Series Reference Manual
(Hardware)
WUME-GM1H Explains the functions and performance of each
GM1 unit.
GM1 Series Reference Manual
(Instruction)
WUME-GM1PGR Explains the specifications of each instruction that
can be used with the GM1 Series.
Copyright / Trademarks
● The copyright of this manual is owned by Panasonic Corporation.
●
Unauthorized reproduction of this manual is strictly prohibited.
● Windows is a registered trademark of Microsoft Corporation in the U.S. and other countries.
● Ethernet is a registered trademark of Fuji Xerox Co., Ltd. and Xerox Corporation.
● EtherNet/IP is a registered trademark of ODVA (Open DeviceNet Vendor Association).
● SDHC and SD logos are trademarks of LLC.
● Other company and product names are trademarks or registered trademarks of their respective companies.
Note on the Software
The "PANATERM Lite for GM" is not incorporated into the GM Programmer as of January 2021.
The features will be added when the GM Programmer is upgraded.
Compliance with IEC 61131
International standard IEC 61131 is the international common standards in which the
International Electrotechnical Commission (IEC) defines programming languages for PLC.
IEC defines the following five programming languages:
●
Ladder Diagram (LD)
● Structured Text (ST)
● Sequential Function chart (SFC)
WUME-GM1RTXOP-01 iii