No. Description
(1)
If the rising edge of the start request bit is detected when the enable request bit is ON, PWM output will
be started.
(2) PWM output is performed with a duty ratio of 50% and at a frequency of 100 Hz.
(3) When the enable request bit turns OFF, PWM output stops.
■
Sample program
The following are LD program and ST program examples for sample POU (PWM).
The state of X0 is output to the Ch0 Enable Request bit.
Ch0 frequency and Ch0 duty ratio are set at the rising edge of X0.
The state of X1 is output to the Ch0 Start Request bit.
LD program
12.5 PWM Output
12-16 WUME-GM1RTXOP-01
To Next Page
Loading...
