ST program
■
Count value when the power is turned on
●
When the power is turned on, the count value is "0".
■
Changing the current count value
● The current count value can be changed to any value as necessary.
● Set a value in the temporary current value channel and turn ON the current value change
request bit.
Example: A program to change the current value of CH0 to 1000000
● Count values cannot be written directly to the count value channel (Ch*_CountValue).
■
Changing the preset value
●
The preset value can be changed to any value as necessary.
● Set a value in the temporary preset value channel and turn ON the preset value change
request bit.
12.6 High-speed Counter Function
12-40 WUME-GM1RTXOP-01
To Next Page
Loading...
