Panasonic KX-NS1000 - Page 1123

Local IP Address
Specifies the IP address of equipment on the LAN.
Default
Not stored
Value Range
1.0.0.1–223.255.255.254
Maintenance Console Location
27.3.1 Router Configuration
—Setup—[1-3-1] LAN—IPv4
LAN Port Start
Specifies the start port for the LAN port range.
If ICMP is selected for Protocol, this item is grayed out.
Note
• If neither the start port nor the end port is set, any port can be used.
• The user cannot reserve system ports for the WAN side.
• If a range is set, ensure that the number of internal ports and external ports match each other.
Default
Blank
Value Range
1–65535
Maintenance Console Location
27.3.1 Router Configuration
—Setup—[1-3-1] LAN—IPv4
LAN Port End
Specifies the end port for the LAN port range.
If this setting is blank, only the port set for LAN Port Start is available for port forwarding.
If ICMP is selected for Protocol, this item is grayed out.
Note
• If neither the start port nor the end port is set, any port can be used.
• The user cannot reserve system ports for the WAN side.
• If a range is set, ensure that the number of internal ports and external ports match each other.
• Ensure that the end range value is greater than the start range value.
Default
Blank
Value Range
1–65535
Document Version 2016-03 PC Programming Manual 1123
27.3.1 Router Configuration—Setup—[1-3-1] LAN—IPv4