WAN QoS—Source—IP Address
Specifies
the IP Address to specify a source. If you did not select Address as Source, this item is grayed out.
Default
Blank
Value Range
Blank, 1.0.0.1–223.255.255.254
Maintenance Console Location
27.12 Router Configuration—QoS Settings—[4] QoS Service
WAN QoS—Source—Subnet Mask
Specifies
the subnet mask to specify a source. If you did not select Subnet as Source, this item is grayed out.
Default
Blank
Value Range
Blank, 0.0.0.0–255.255.255.255
Maintenance Console Location
27.12 Router Configuration—QoS Settings—[4] QoS Service
WAN QoS—Destination
Selects the method of specifying a destination IP address.
If ANY is selected for Destination, QoS is available for all IP addresses.
If Address is selected for Destination, enter the IP address for IP Address below.
If Subnet is selected for Destination, enter the subnet mask for Subnet Mask below.
Default
ANY
Value Range
ANY, Address, Subnet
Maintenance Console Location
27.12 Router Configuration
—QoS Settings—[4] QoS Service
WAN QoS—Destination—IP Address
Specifies the IP Address to specify a destination. If you did not select Address as Destination, this item is
grayed out.
Default
Blank
Document Version 2016-03 PC Programming Manual 1181
27.12 Router Configuration—QoS Settings—[4] QoS Service
To Next Page
Loading...
