Multisite
Voice Activity Detection for G.711
Enables
the use of the Voice Activity Detection feature for the G.711 codec. This feature conserves bandwidth
by detecting silent periods during a call and suppressing the packets of silence from being sent to the network.
Default
Disable
Value Range
Disable, Enable
Maintenance Console Location
9.4 PBX Configuration—[1-1] Configuration—Slot—System Property
DTMF
Specifies the type of DTMF tone to be sent out.
Default
Inband
Value Range
Inband, Outband (RFC2833)
, Outband (H.245)
Maintenance Console Location
9.4 PBX Configuration—[1-1] Configuration—Slot—System Property
Payload Type
Specifies
the payload type for DTMF tones using RFC2833. Programming this parameter is only necessary if
DTMF is set to Outband (RFC2833).
Default
101
Value Range
96–127
Maintenance Console Location
9.4 PBX Configuration—[1-1] Configuration—Slot—System Property
Multisite message resend time
Specifies the re-sending time for message communication between the Master unit and Slave units.
Default
500 ms
Document Version 2016-03 PC Programming Manual 219
9.4 PBX Configuration—[1-1] Configuration—Slot—System Property
To Next Page
Loading...
