Panasonic KX-NS1000 - Page 220

Value Range
500–8000 ms, in units of 500 ms
Maintenance Console Location
9.4 PBX Configuration—[1-1] Configuration
—Slot—System Property
Multisite message resend expired time
Specifies
the number of seconds after which a message being re-sent between the Master unit and Slave units
will timeout if it cannot be sent.
Default
150 s
Value Range
150–240 s
Maintenance Console Location
9.4 PBX Configuration—[1-1] Configuration—Slot—System Property
Multisite for PBX UDP port number
Specifies the first of two contiguous UDP ports to be used for Type 1 message communication between the
Master unit and Slave units.
Default
4562
Value Range
1024–65534
Maintenance Console Location
9.4 PBX Configuration—[1-1] Configuration
—Slot—System Property
Multisite message UDP port number
Specifies the UDP port to be used for Type 2 message communication between the Master unit and Slave
units.
Note
The UDP port specified here and the next contiguous port will be assigned for transmission.
Example: If the value set here is 4560, ports 4560 and 4561 will be assigned.
Default
4560
Value Range
1024–65535
220 PC Programming Manual Document Version 2016-03
9.4 PBX Configuration—[1-1] Configuration—Slot—System Property