Panasonic KX-NS1000 - Page 443

Maintenance Console Location
9.26 PBX Configuration—[1-1] Configuration—Slot—Card Property - PRI type
ISDN CO / QSIG Master / QSIG Slave—T305
Specifies the maximum time that the PBX waits for a reply after sending the DISC
(disconnection) message
to ISDN.
Default
300
Value Range
0–3000 ´ 100 ms
Maintenance Console Location
9.26 PBX Configuration—[1-1] Configuration—Slot—Card Property - PRI type
ISDN CO / QSIG Master / QSIG Slave—T308
Specifies the maximum time that the PBX waits for a reply after receiving the Release message from ISDN.
Default
40
Value Range
0–600 ´ 100 ms
Maintenance Console Location
9.26 PBX Configuration
—[1-1] Configuration—Slot—Card Property - PRI type
ISDN CO / QSIG Master / QSIG Slave—T309
Specifies the length of time that the PBX tries to disconnect the data link, before disconnecting the call.
Default
120
Value Range
0–3000 ´ 100 ms
Maintenance Console Location
9.26 PBX Configuration
—[1-1] Configuration—Slot—Card Property - PRI type
ISDN CO / QSIG Master / QSIG Slave—T310
Specifies the maximum time that the PBX waits for a continuance message after receiving the Incoming Call
Proceeding message.
Document Version 2016-03 PC Programming Manual 443
9.26 PBX Configuration—[1-1] Configuration—Slot—Card Property - PRI type