Maintenance Console Location
10.3 PBX Configuration—[2-3] System—Timers & Counters
Feature Manual References
6.1.12 External Sensor
Incoming Call Inter-digit Timer—DDI / DID
Specifies the length of time between digits when receiving a DID number from a public network. The call will
be redirected to a PBX operator when this timer expires.
Default
10
Value Range
0–30 s
Maintenance Console Location
10.3 PBX Configuration
—[2-3] System—Timers & Counters
Programming Manual References
18.3 PBX Configuration—[10-3] CO & Incoming Call—DDI / DID Table
Feature Manual References
5.1.7 DID (Direct Inward Dialing)
Incoming Call Inter-digit Timer—TIE
Specifies the length of time between digits when receiving a dialed number from a TIE line. The call will be
redirected to a PBX operator when this timer expires.
Default
10
Value Range
3–30 s
Maintenance Console Location
10.3 PBX Configuration
—[2-3] System—Timers & Counters
Programming Manual References
17.1 PBX Configuration—[9-1] Private Network—TIE Table
Feature Manual References
15.1.12 PRIVATE NETWORK FEATURES
508 PC Programming Manual Document Version 2016-03
10.3 PBX Configuration—[2-3] System—Timers & Counters
To Next Page
Loading...
