During Conversation—DTMF Signal Length
Specifies the length of time that a DTMF signal is sent when a number is dialed from a PT or PS during a
conversation.
Default
160 ms
Value Range
80 ms, 160 ms, 240 ms, 320 ms
Maintenance Console Location
10.3 PBX Configuration
—[2-3] System—Timers & Counters
During Conversation—DTMF Inter-digit Pause
Specifies the length of time between DTMF signals when numbers are dialed in succession from a PT or PS
during a conversation.
Default
112
Value Range
64 + 16 ´ n (n=0–15) ms
Maintenance Console Location
10.3 PBX Configuration
—[2-3] System—Timers & Counters
During Conversation—Pause Signal Time
Specifies the length of the pause inserted when the PAUSE button is pressed during a conversation.
Default
1.5 s
Value Range
1.5 s, 2.5 s, 3.5 s,
4.5 s
Maintenance Console Location
10.3 PBX Configuration—[2-3] System—Timers & Counters
Feature Manual References
15.1.2 Pause Insertion
System Wireless—PS Out of Range Timer
When the destination of an incoming call is a PS, specifies the length of time the PBX searches for the PS
before setting its status to Out of Range.
If "0" is assigned, the timer is controlled by the cell station.
510 PC Programming Manual Document Version 2016-03
10.3 PBX Configuration—[2-3] System—Timers & Counters
To Next Page
Loading...
