Embroidery Stitch-Out
Auto Smart Save
If a power outage has occurred, you will see this pop-up
message when the machine is restarted. Touch OK in
the pop-up to return to Embroidery Stitch-Out. This will
load the design ready to stitch from approximately the
same position it was interrupted.
Tip: Before starting the embroidery go back a few stitches
using the Step Stitch-by-Stitch to ensure that the threads will
be secured.
Change Needle (Optional Accessory)
Cutwork designs and felting designs require special
optional needle accessories. Cutwork designs require
the creative™ Embroidery Cutwork Needle Kit (820945-
096) and felting designs require the creative™ Felting
Embroidery Set (821068-096).
When the machine stops and this pop-up message is
shown, insert the corresponding optional needle. Touch
OK and press the Start/Stop button to resume.
Cutwork designs are marked with a cutwork needle
symbol and felting designs are marked with a felting
needle symbol in the creative icon™ embroidery
collection.
Note: Cutwork designs can also be stitched out without using
the cutwork needles. The cutwork area will then have to be cut
manually and the color block for the cutwork needle in the
color block list should be skipped.
Attention!
If the machine stops and this pop-up appears on the
screen you cannot continue embroidering. Wait a
moment and touch OK when it is enabled. Check needle
size and condition and check that your machine is
threaded correctly.
149
To Next Page
Loading...
