The Multi-Touch Screen
Automatic Thread Cutter
When selected, the threads are cut automatically in the
following situations:
• At cut commands in stitches and sequences.
• After sewing a single stitch e.g. a monogram or
eyelets.
If deselected, no automatic thread cut will be performed.
Note: Deselect when using optional accessories that are
attached in the two holes in the needle plate just above the
bobbin cover, to prevent damage to the automatic thread
cutter knife located under the needle plate.
Free-Motion Options
Free-Motion Options
Choose between three Free-Motion Options; Dynamic
Spring Foot 6D Free-Motion, Spring Foot Free-Motion
and Sensormatic Free-Motion. When one of the Free-
Motion Options is selected the corresponding Free-
Motion mode will automatically be selected in the
Temporary Settings for all new projects or sewing
sessions.
It is recommended that you do not set an option for
free-motion in the Default Settings; touch the Free-
Motion icon in Sewing Mode to choose a temporary
option instead.
For more information see the description in the Free-
Motion Options in Sewing Mode.
Stitch Limiting Options
Stitch Limiting Options
Set the machine to Stitch Width Safety or select the size
of the twin needle to limit the stitch width and stitch
positioning. This will minimize the risk of breaking a
needle when sewing with accessories that do not allow
the use of the entire stitch width.
Needle Stop Position
Needle Stop Position
When Up is selected your machine stops with the
needle up. When Down is selected your machine stops
with the needle down.
This setting can also be set by touching the Needle Up/
Down button on the front of the machine.
Presser Foot Pressure
Presser Foot Pressure
In most cases, you do not need to adjust the presser foot
pressure. Specialty techniques may require an
adjustment. The higher the number the more pressure
on the fabric.
60
To Next Page
Loading...
Need help?
General
