Chapter 5: Management with the CLU
143
4. Highlight the battery you want to monitor and press Enter.
5. Highlight Recondition Battery and press Enter.
6. Press Y to confirm.
During reconditioning, Battery status can show “discharging” and
“recharging”, and a value will display next to Current. During that time, the
controller cache is reset to Write Thru. Reconditioning runs in the
background and stops automatically upon completion.
VTrak automatically reconditions the battery every two months.
Locating an Enclosure
This feature helps you identify the physical VTrak enclosure you are working with
through the CLU.
1. From the Main Menu, highlight Subsystem Management and press Enter.
2. Highlight Enclosure Management and press Enter.
3. Highlight Locate Enclosure and press Enter.
The LEDs on the front of the VTrak will blink for one minute.
To Next Page
Loading...