VTrak M610i, M310i, M210i Product Manual
204
Replacing a Power Supply
The power supply and its fans are replaced as one unit. There are no individually
serviceable parts. No tools are required for this procedure.
Remove the Old Power Supply
To remove the power supply:
1. Verify that the power supply LED is amber or red.
2. Switch off the power.
3. Unplug the power cord.
4. Press the release button and pull the handle downward as shown. See
Figures 1 and 2.
5. Pull the power supply out of the VTrak enclosure.
Install a New Power Supply
To install the power supply:
1. Carefully slide the power supply into the enclosure.
2. Gently press the handle in and upward until it locks. See Figures 1 and 2.
3. Plug in the power cord.
4. Switch on the power supply.
5. Verify that the new power supply LED is green.
Figure 1. Replacing a M610i power supply
To Next Page
Loading...