Promise Technology VTrak M610i User Manual

Chapter 3: Setup
29
Creating Disk Arrays with WebPAM PROe
Setting up disk arrays with WebPAM PROe consists of the following actions:
• Logging into WebPAM PROe (below)
• Selecting a Language (page 31)
• Creating a Disk Array (page 31)
• Logging out of WebPAM PROe (page 35)
• Using WebPAM PROe over the Internet (page 36)
• Optional. Obtaining a Security Certificate (page 36)
Logging into WebPAM PROe
1. Launch your Browser.
2. In the Browser address field, type in the IP address of the VTrak subsystem.
Use the IP address you set in the CLI (page 25) or CLU (page 27). Note that
the IP address shown below is only an example. The IP address you type
into your browser will be different.
Regular Connection
• WebPAM PROe uses an HTTP connection. . . . . . . . . . . . . . . .http://
• Enter the VTrak’s Management Port IP address . . . . 192.168.1.105
Together, your entry looks like this:
http://192.168.1.105
Secure Connection
• WebPAM PROe uses a secure HTTP connection. . . . . . . . . .https://
• Enter the VTrak’s Management Port IP address . . . . 192.168.1.105
Together, your entry looks like this:
https://192.168.1.105
Note
You can also use the CLU to create disk arrays and logical drives.
See “Creating a Disk Array” on page 147 for more information.
Note
Whether you select a regular or a secure connection, your login to
WebPAM PROe and your user password are always secure.

Promise Technology VTrak M610i Specifications

General

Brand	Promise Technology
Model	VTrak M610i
Category	Network Storage Server
Language	English