VTrak M610i, M310i, M210i Product Manual
188
The mark is an asterisk (*) to the left of the listing.
4. Highlight Delete Marked Entries and press Enter.
Making CIM Settings
By default, CIM (Common Information Model [a protocol]) service is set to
Automatic and its normal status is Started.
To make CIM service settings:
1. From the Main Menu, highlight Additional Info and Management and press
Enter.
2. Highlight Software Management and press Enter.
3. Highlight CIM and press Enter.
4. Highlight Startup Type and press the spacebar to toggle between Automatic
and Manual.
5. Highlight HTTP and press the spacebar to toggle between Enabled and
Disabled.
6. Highlight HTTP Port, press the backspace key to erase, type new value.
5988 is the default port number.
7. Highlight HTTPS and press the spacebar to toggle between Enabled and
Disabled.
8. Highlight HTTPS Port, press the backspace key to erase, type new value.
5989 is the default port number.
9. Highlight Authentication and press the spacebar to toggle between Enabled
and Disabled.
Note: There is only one user. The default name is cim. No changes are
possible.
Note: CIM service must be running to change the password.
The default password is password.
10. Highlight Change Password... and press Enter to change the password.
11. Highlight Old Password and type the current password.
12. Highlight New Password and type a new password.
13. Highlight Retype Password and type the new password again.
14. Press Ctrl-A to save your settings.
To start, stop or restart the CIM service, highlight Start, Stop, or Restart and press
Enter.
Making Netsend Settings
By default, Netsend service is set to Manual and its normal status is Stopped.
To Next Page
Loading...
Need help?
General
