Promise Technology VTrak M610i User Manual

Chapter 5: Management with the CLU
163
Making iSCSI Data Port Settings
The network settings for the iSCSI data ports are located under the Network
Management and are described below. For the iSCSI settings for the iSCSI data
ports, see “Managing iSCSI Connections” on page 167.
Making Automatic Settings
1. From the Main Menu, highlight Network Management and press Enter.
2. Highlight the iSCSI port in the list and press Enter.
3. Highlight NetMgmt iSCSI Port Settings and press Enter.
4. Highlight DHCP and press the spacebar to toggle to Enable.
5. Highlight TCP Port Number, and press the backspace key to erase the
current value, then type the new value.
Use 1 to 65535. The default is 3260.
6. Highlight Jumbo Frame and press the spacebar to toggle between Enabled
and Disabled.
7. Press Ctrl-A to save your settings.
Making Manual Settings
1. From the Main Menu, highlight Network Management and press Enter.
2. Highlight the iSCSI port in the list and press Enter.
3. Highlight NetMgmt iSCSI Port Settings and press Enter.
4. Highlight DHCP and press the spacebar to toggle to Disabled.
5. Highlight each of the following and press the backspace key to erase the
current value, then type the new value.
• IP Address
• Subnet Mask
• Gateway IP Address
6. Highlight TCP Port Number, and press the backspace key to erase the
current value, then type the new value.
The default is 3260.
7. Highlight Jumbo Frame and press the spacebar to toggle between Enabled
and Disabled.
8. Press Ctrl-A to save your settings.

Promise Technology VTrak M610i Specifications

General

Brand	Promise Technology
Model	VTrak M610i
Category	Network Storage Server
Language	English