Promise Technology VTrak M610i - Accepting an Incomplete Array; Enabling Media Patrol on a Disk Array; Enabling PDM on a Disk Array; Preparing the Disk Array for Transport

Chapter 5: Management with the CLU
153
Maximum of 32 characters. Use letters, numbers, space between words and
underscore. An alias is optional.
4. Press Ctrl-A to save your settings.
Accepting an Incomplete Array
This condition is the result of a missing physical drive. See “Incomplete Array” on
page 272 before you use this function.
To accept an incomplete array:
1. From the Main Menu, highlight Disk Array Management and press Enter.
2. Highlight the disk array you want and press Enter.
3. Highlight Accept Incomplete Array and press Enter.
Enabling Media Patrol on a Disk Array
Media Patrol checks the magnetic media on physical drives.
To run Media Patrol on a disk array:
1. From the Main Menu, highlight Disk Array Management and press Enter.
2. Highlight the disk array you want and press Enter.
3. Highlight Media Patrol and press the spacebar to toggle between Enable and
Disable.
4. Press Ctrl-A to save your settings.
Enabling PDM on a Disk Array
This function enables and disables Predictive Data Migration (PDM).
To enable or disable PDM:
1. From the Main Menu, highlight Disk Array Management and press Enter.
2. Highlight the disk array you want and press Enter.
3. Highlight PDM and press the spacebar to toggle between Enable and
Disable.
4. Press Ctrl-A to save your settings.
See “Running PDM” on page 155.
Preparing the Disk Array for Transport
To run the Transport function on a disk array:
1. From the Main Menu, highlight Disk Array Management and press Enter.
2. Highlight the disk array you want and press Enter.