Promise Technology VTrak M610i User Manual

VTrak M610i, M310i, M210i Product Manual
28
4. Follow the same procedure to specify the Subnet Mask, Gateway IP
Address and DNS Server IP Address.
If you do not have a DNS server, skip the DNS Server IP address.
5. Press Ctrl-A to save these settings and move to the iSCSI Port 1 screen.
Automatic IP settings
To make Management Port settings automatically:
1. Press the arrow keys to highlight DHCP.
2. Press the spacebar to toggle to Enable.
3. Press Ctrl-A to save these settings and move to the iSCSI Port 1 screen.
Making iSCSI Data Port settings
Manual IP settings
To make iSCSI Data Port settings manually:
1. Press the arrow keys to highlight IP Address.
2. Press the backspace key to erase the current IP Address.
3. Type the new IP Address.
4. Follow the same procedure to specify the Subnet Mask, Gateway IP
Address and DNS Server IP Address.
If you do not have a DNS server, skip the DNS Server IP address.
5. Press Ctrl-A to save these settings and move to the iSCSI Port 2 screen.
6. Follow the same procedure to make settings for iSCSI Port 2.
7. Press Ctrl-A to save these settings.
Automatic IP settings
To make iSCSI Data Port settings automatically:
1. Press the arrow keys to highlight DHCP.
2. Press the spacebar to toggle to Enable.
3. Press Ctrl-A to save these settings and move to the iSCSI Port 2 screen.
4. Follow the same procedure to make settings for iSCSI Port 2.
5. Press Ctrl-A to save these settings.
Exiting the CLU
1. Highlight Skip the Step and Finish and press Enter.
2. Highlight Return to CLI and press Enter.
This completes the Management and iSCSI Port setup. Go to “Creating Disk
Arrays with WebPAM PROe” on page 29.

Promise Technology VTrak M610i Specifications

General

Brand	Promise Technology
Model	VTrak M610i
Category	Network Storage Server
Language	English