RADWAG PUE HY10

134
Quantity of
packages
Declaring quantity of packages to be controlled
for determining average tare (for control type
“non-destructive average tare”)
Cyclic
displaying of
average tare
Turning on
/ turning off an option of
cyclic estimation of average tare for a product.
Interval of
average tare
determination
[h]
Value of time determining frequency of tare
control during a process of product control.
This means that estimation of average tare
for a product will be carried out in accord with
declared interval.
Remind about
measurement
every [min]
Aktywacja komunikatu przypominającego o
konieczności wykonania kolejnego pomiaru
Internal control
Submenu for defining internal criteria of a
control (see table below)
• List of data for internal criteria
Internal control
Enabling
/ disabling internal control
criteria
Sample quantity
Quantity of a product sample
Error value [- T]
Value of negative permissible error
–T
, set in a
weighing unit determined for the product.
Measurements below the Qn-T value will
be comprehended as defective.
Error value [+ T]
Value of positive permissible error +T set in
a weighing unit determined for the product.
Measurements above the Qn+T value will
be comprehended as defective.
Quantity of disqualifying
samples [Qn – 2T]
Number of recorded negative errors -2T in
a tested sample that disqualifies a control
Quantity of disqualifying
samples [Qn + 2T]
Number of recorded positive errors
+2T
in
a tested sample that disqualifies a control
Quantity of disqualifying
samples [Qn – T]
Number of recorded negative errors -T in
a tested sample that disqualifies a control
Quantity of disqualifying
samples [Qn + T]
Number of recorded positive errors +T in
a tested sample that disqualifies a control
Average limit value
Mode for calculating the average limit value
(constant or automatic)