Where:
Product
- Name of the controlled product
Code
- Code of the controlled product
- Nominal value of the controlled product
- Average mass of the controlled product
- Value of the disqualifying average
Characteristics of negative errors T1 in a sample
(in accordance with ch. 30.6 of the manual)
Characteristics of negative errors 2T1 in a sample
(in accordance with ch. 30.6 of the manual)
- Net mass of the controlled product
- Tare of the packaging
Status
- Control status (in accordance with ch. 30.6)
Put Empty 1/10
- Commands on control process
(1/3)
Value of the measuring lot
Data on a control process in progress
(in accordance with ch. 30.6 of the manual)
- Control completion
After the test has been completed the test is summarized (see ch. 30.8)
and the results are automatically saved in the database.
Caution:
A pattern and example of the report from estimating average tare are described
in ch. 30.14 of this manual.
30.10. Performing destructive testing in modes Empty-Full and Full-
Empty
“Destructive” control process complying with the regulation, and independently
on the batch size that exceeds 100 pcs., the size of a sample accepted by the
software for control process is 20 pcs. Other control criteria are accepted as
specified in the regulation.
To Next Page
Loading...
