• Signaling mass above the set value of Qn+2T:
Caution:
In case of additional declaring the values for MIN, MAX limits, the “control”
bargraph refers to the MIN, MAX limits and the nominal mass, but without
displaying the errors for T and 2T.
18. INPUTS / OUTPUTS
Weighing indicator are equipped with 4 inputs / 4 outputs. To adjust software to
the users needs configure inputs outputs in the submenu
in the submenu <
Inputs / Outputs>:
• indicator inputs,
•
indicator outputs.
In order to enter submenu < Inputs / Outputs>, press and then:
„ Inputs / Outputs”.
18.1. Configuration of inputs
Procedure:
• Enter < Inputs / Outputs> according to ch. 18 of this manual,
• Choose < Inputs> and enter the selected input you will see
a list of functions to ascribe,
• Choose the required function from the list and return to weighing
saving the changes according to ch. 12.2 of this manual.
Caution:
The list of functions to ascribe to inputs are described in APPENDIX 02
of this manual. By default inputs have no ascribed functions <None>.
To Next Page
Loading...
