13.3. Tarring
In order to tare the scale choose a platform on the touch panel if necessary, put
a package on the pan and press
. You will see the indication equal zero
and following symbols usually appear: Net and
.
After placing a load on the weight pan net mass will be shown. Tarring is
possible within the whole range of the scale. After unloading the pan the
display shows the tarred value with minus sign.
You can also enter tare values to the product database. Every product has a
field “Tare”. In that case tare is automatically set to this value after selecting the
product.
Caution:
Tarring cannot be executed when a negative or zero value is being
displayed. In such case the following message will be displayed:
13.4. Weighing for dual range scales
Switching between the I range and the II range happens automatically
(exceeding Max of the I range).
Weighment in the second range is signalled by a pictogram in the top left
corner of the display
. Then weighment is done with the accuracy
of the II range to the moment of returning to zero (autozero range
)
where the scale switches back to the I range.
To Next Page
Loading...
