Enter this parameter to enable automatic control and correction of
zero indication. There are, however, some cases when this
function can be a disturbing factor for the measuring process. e.g.
very slow placing of a load on the weighing pan (load adding, e.g.
pouring, filling). In such case, it is recommended to disable the
function. Available options: - function disabled, - function
enabled.
Enter this parameter to enable/disable display of the last digit
(placed on the right of the decimal point) of the weighing result.
Available values: Always: all digits are displayed; Never: last digit
disabled; When stable: last digit displayed only when the result is
stable.
53.2. LO Threshold for automatic functions
<LO threshold> parameter allows you to configure the function of automatic
operation. The next measurement is saved when mass indication gets below
the set net value of <LO threshold> parameter.
Procedure:
• Enter <
Weighing / LO threshold> submenu, an on-screen
keyboard is displayed.
• Enter LO threshold value and press
button.
53.3. Automatic adjustment
Automatic adjustment using internal adjustment weight is carried out in 3
different cases:
• Triggered by plugging the instrument to the mains.
• Triggered by temperature change (by 3°C).
• Triggered by passage of specified time interval (every 3h).
Enabling <
Automatic adjustment> parameter:
• Enter <
Weighing> submenu.
• Select <
Automatic adjustment> parameter and set respective value
(
- function disabled, - function enabled).
Automatic adjustment process:
• Upon detecting the need for carrying out an adjustment process, the
following message is displayed:
To Next Page
Loading...
