After selecting from a list a product with set options for the destructive control
with determined measuring “lot”, and starting the control process, the software
will display messages facilitating the control process (as in the case of control
process described above).
Depending on the set control mode, the scale orders the following sequence of
weighing products: “empty-full” or “full-empty”.
Caution:
Remember to maintain the order for weighing products with packages and
empty packages. It is important to the software that carries out mass
calculations of products placed in a specific packaging.
After the test has been completed the test is summarized (see ch. 30.8)
and the results are automatically saved in the database.
Caution:
A pattern and example of the report from estimating average tare are described
in ch. 30.14 of this manual.
30.11. Control in accordance with internal criteria
Select a product with correctly determined parameters for carrying out the
control in accordance with the internal criteria (see ch. 30.4 of this manual).
After entering to scale memory general parameters of the working mode (in
accordance with ch. 30.2 and ch. 30.3 of this manual), start control process
by pressing
key (control start) located in the bottom bar of the mode
settings window. The scale automatically displays a window with data on set
control parameters:
To Next Page
Loading...
