• After scanning the code is entered to the ASCII field and HEX filed
and at the bottom of the window a test result is displayed.
When:
• <Prefix> and <Suffix> declared in settings are the same as
<Prefix> and <Suffix> in the read code then the test result is <Positive>,
• <Prefix> and <Suffix> declared in settings are not the same as
<Prefix> and <Suffix> in the read code then the test result is <Negative>.
16.5. Transponder card reader
Each time after turning on the device, it is possible to select (log in)
the operator using a transponder card reader and a transponder card.
Caution:
In case of problems with reading transponder cards check the submenu
<
Communication> and set appropriate baud rate (default 9600b/s).
16.5.1. Com port for transponder card readers
Procedure:
• Enter group of parameters < Devices> according to ch. 16 of this
manual, select „
Transponder cards reader / Port” and set
appropriate option.
The scale can communicate with the reader via following ports:
• RS232 (1),
• RS232 (2).
To Next Page
Loading...
