RADWAG PUE HY10

88
• Set accessibility attribute for each of the working modes and return
to weighing mode.
24.2. Save mode
Depending on setting parameter < Save Mode> users can send data from
the scale to an external device.
Procedure:
• Enter parameters group < Working modes> according
to ch. 24 of this manual,
• Enter the required mode and choose <
Save Mode> then choose the
required mode.
Accessible options:
Manual every stable
-
Manual printout of each stable weighing result for mass
measurement over -LO- threshold
Manual first stable
-
Manual printout of the first stable weighing result for mass
measurement over -LO- threshold
Automatic first stable
-
Automatic printout of the first stable weighing result for mass
measurement over -LO- threshold
Automatic last stable
-
Automatic printout of the last stable weighing result for mass
measurement below -LO- threshold
Semi-automatic every
stable
-
Manual printout of each weighing result for mass
measurement over -LO- threshold – awaiting for a stable result
Semi-automatic first
stable
-
Manual printout of the first weighing for mass measurement
over -LO- threshold – awaiting for a stable result
24.3. Down-weighing
Software allows to weigh in the “down-weighing” mode. It consist in putting the
load on the pan and taking off/removing portions of it with concurrent saving
weighments equal to the portions taken off the pan.