Average limit value [ - ]
Average limit value (negative) for a tested sample
(refers to average limit value as a “constant”)
Average limit value [ + ]
Average limit value (positive) for a tested sample
(refers to average limit value as a “constant”)
Factor value [- Wk]
Standard deviation multiplier for the average limit
value (negative) determined in the automatic mode
Factor value [+ Wk]
Standard deviation multiplier for the average limit
value (positive) determined in the automatic mode
30.5. Control start procedure
To start testing:
• An operator needs to be logged on with the authorization access level high
enough to perform testing.
Caution:
The Logging on procedure is described in ch. 11. The procedure
of outlining the authorization level is described in ch. 19 of this manual.
• Select a product to be tested with correctly determined data for the control
process,
• Enter to scale memory general parameters on control mode (in
accordance with ch. 30.2 and 30.3 of the manual),
• Remove load from the weighing pan,
• Press function hot-key
(control start) located in the bottom bar
of the settings window, which opens an information window on entered
data:
To Next Page
Loading...
