5.5. Inputs/Outputs
Standard version of the indicator features 4 optoisolated inputs and 4 solid-
state relay outputs. Signals are fed through M12 8P connectors.
4OUTPUTS
Pin1 – OUT1
Pin2 – OUT2
Pin3 – OUT3
Pin4 – OUT4
Pin5 – COMM
Pin6 – 24VDC
Pin7 – GND
Pin8 – NC
4OUTPUTS
Pin1 – IN1
Pin2 – IN2
Pin3 – IN3
Pin4 – IN4
Pin5 – COMM
Pin6 – 24VDC
Pin7 – GND
Pin8 – NC
5.5.1. Inputs/Outputs: technical specifications
Output parameters
Outputs number 4
Outputs type Solid-state relay
Wire cross-section 0,14 - 0,5mm
Maximum switching current 0,5A DC
Maximum forward voltage 30VDC, AC
If the device is switched on in a factory setup mode all factory parameters can be
changed
Inputs number 4
Inputs type Optoisolated
Wire cross-section 0,14 – 0,5mm
To Next Page
Loading...
