R&S FSPN - Page 421

Remote Control
R&S
®
FSPN
421User Manual 1179.4363.02 ─ 01
POINt
Uses a point as decimal separator, e.g. 4.05.
*RST: *RST has no effect on the decimal separator.
Default is POINt.
Example:
FORM:DEXP:DSEP POIN
Sets the decimal point as separator.
Manual operation: See " Decimal Separator " on page 160
FORMat:DEXPort:FORMat
<FileFormat>
Determines the format of the ASCII file to be imported or exported. Depending on the
external program in which the data file was created or will be evaluated, a comma-sep-
arated list (CSV) or a plain data format (DAT) file may be required.
Parameters:
<FileFormat> CSV | DAT
*RST: DAT
Example:
FORM:DEXP:FORM CSV
Manual operation: See " File Type " on page 160
FORMat:DEXPort:HEADer <State>
If enabled, additional instrument and measurement settings are included in the header
of the export file for result data. If disabled, only the pure result data from the selected
traces and tables is exported.
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1
Manual operation: See " Include Instrument & Measurement Settings " on page 159
FORMat:DEXPort:TRACes <Selection>
This command selects the data to be included in a data export file (see MMEMory:
STORe<n>:TRACe on page 473).
Parameters:
<Selection> SINGle | ALL
SINGle
Only a single trace is selected for export, namely the one speci-
fied by the MMEMory:STORe<n>:TRACe command.
Common Analysis and Display Functions