R&S FSPN - Page 430

Remote Control
R&S
®
FSPN
430User Manual 1179.4363.02 ─ 01
Example: //Assign marker to trace 1
CALC:MARK3:TRAC 2
Manual operation: See " Assigning the Marker to a Trace " on page 169
CALCulate<n>:MARKer<m>:X <Position>
This command moves a marker to a specific coordinate on the x-axis.
If necessary, the command activates the marker.
If the marker has been used as a delta marker, the command turns it into a normal
marker.
Suffix:
<n>
.
Window
<m> Marker
Parameters:
<Position> Numeric value that defines the marker position on the x-axis.
The unit depends on the result display.
Range: The range depends on the current x-axis range.
Default unit: Hz
Example:
CALC:MARK2:X 1.7MHz
Positions marker 2 to frequency 1.7 MHz.
Manual operation: See " Marker Table " on page 96
See "Marker Position X-value " on page 168
11.7.4.2 General Marker Settings
DISPlay[:WINDow<n>]:MTABle....................................................................................... 430
CALCulate<n>:MARKer<m>:LINK................................................................................... 431
DISPlay[:WINDow<n>]:MTABle <DisplayMode>
This command turns the marker table on and off.
Suffix:
<n>
.
irrelevant
Parameters:
<DisplayMode> ON | 1
Turns on the marker table.
OFF | 0
Turns off the marker table.
*RST: AUTO
Example:
DISP:MTAB ON
Activates the marker table.
Manual operation: See " Marker Table Display " on page 170
Common Analysis and Display Functions