Build 21 v21.4.1
FEBRUARY 23, 2010 © 2007-2010 RED.COM INC.
43
BURST TYPE
Burst type specifies the type of burst recording. To adjust: Select BURST TYPE and twist joystick to
change the highlighted FRAMES ARE box to REPEATED or UNIQUE (default is UNIQUE.)
REPEATED: Specifies that each frame captured during the burst record be repeated. That is for each
Time-lapse event, a single frame is repeated N times, where N is the Step print value.
UNIQUE: Specifies that each frame captured during the burst record is unique. That is for each Time-
lapse event, N frames are captured and recorded, where N is the Step print value.
NOTE: When recording in Time-lapse mode, the RECORD tally lamp will remain illuminated.
Each successive event uses the next available Edge Code and Time Code value and uses the existing clip
name. This results in a complete Time-lapse sequence with a single clip name and correct timecode se-
quence. To exit Time-lapse mode, push the RECORD button.
To Next Page
Loading...
