Build 21 v21.4.1
© 2007-2010 RED.COM INC. FEBRUARY 23, 2010
6 6
The recommended storage and usage temperatures for your camera, lenses and other accessories are:
- Operating range: 0°C to +40°C (32°F to 104°F)
- Storage range: -20°C to +50°C (-4°F to 122°F)
If there are any performance issues with your camera or accessories within this operating range, please
file a support ticket on www.RED.com/support.
MOISTURE: Avoid exposing your camera to moisture. The unit is not waterproof, so contact with water
could cause permanent damage to the unit as well as electric shock and serious injury to the user. Do not
use the camera in the rain or under other conditions with high moisture and immediately remove the pow-
er source if exposed to moisture.
AVOID SHOCK: Do not expose your camera to excessive vibration or impact. Be careful not to drop your
camera. Internal mechanisms may be damaged by severe shock. Mechanical alignment of optical ele-
ments may be affected by excessive vibration.
CLEANING: When cleaning your camera, remember that it is not waterproof and moisture can damage
electronic circuitry. Do not rinse or immerse any element of the camera, lens or other accessory, keep
them dry at all times. Do not use soaps, detergents, ammonia, alkaline cleaners, and abrasive cleaning
compounds or solvents. These substances may damage lens coatings and electronic circuitry.
LASER BEAMS: Avoid imaging of laser beams as they may cause damage to the sensor.
BATTERY: Lithium Ion batteries may be subject to special handling requirements pursuant to federal and
local laws. Please refer to specific shipping instructions included with your battery regarding proper trans-
port of your battery. Do not handle your battery if it is damaged or leaking. Disposal of batteries must be in
accordance with local environmental regulations. For example, California law requires that all rechargeable
batteries must be recycled by an authorized recycle center.
ELECTROMAGNETIC INTERFERENCE: The use of devices using radio or other communication waves
may result in the malfunction or interference with the unit and/or with audio and video signals.