ECODRIVE03 Drive Controllers ECODRIVE03 DKC**.040, DKC**.100, DKC**.200 4-83
n
sRevolution
QuantityLine
f •=
f: output frequency
n: velocity (rotary)
Fig. 4-128: Calculating the output frequency f
Note: The output frequency results from the parameter setting.
=> See also rmware functional description: "Encoder
Emulation".
Note: Conditionally due to the internal signal processing the period
duration and the duty cycle of the signals put out vary.
Therefore the following requirements of the signal ltering for
UA1 and UA2 arise.
• f ≥ 500 kHz f
Pass
≥ 1 MHz
• f < 500 kHz f
Pass
≥ 2 x f
Note: The frequency measurement is not suitable for the RPM
measurement derived from the incremental emulator signals.
Output frequency f:
Pass-band width of the
controller-side signal ltering for
UA1 and UA2::
RPM Measurement:
customerservice@hyperdynesystems.com | (479) 422-0390
To Next Page
Loading...
Need help?
General
