Ricoh PRO C7210

1.SC Codes
149
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC700-
04
D
Entrance Motor error (1-pass ADF)
Error signal detected while the motor is driven.
 Motor defective
 Connecter disconnected
 Harness broken
 Overload
Check if the SC occurs (feed paper, open/close the doors, Input or Output check).
If the SC occurs again, do the following steps.Check if the SC reoccurs by cycling
the power after each step.
1. Check the harness connection.
2. Replace the encoder harness.
3. Replace the Entrance Motor.
4. Remove torn paper from the paper path, remove foreign objects from the
drive area, and check for motor/motor bracket deformation.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC700-
05
D
Pickup Roller Motor error (1-pass ADF)
Error signal detected while the motor is driven.
 Motor defective
 Connecter disconnected
 Harness broken
 Overload
Check if the SC occurs (feed paper, open/close the doors, Input or Output check).
If the SC occurs again, do the following steps.Check if the SC reoccurs by cycling
the power after each step.
1. Check the harness connection.
2. Replace the encoder harness.
3. Replace the Pickup Roller Motor.
4. Remove torn paper from the paper path, remove foreign objects from the
drive area, and check for motor/motor bracket deformation.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC700-
06
D
Transport Motor error (1-pass ADF)
Error signal detected while the motor is driven.
 Motor defective
 Connecter disconnected