11.Image Quality Problem: Full Page
638
*1 A3 SEF more than 50 sheets
After taking the above measures, do the color calibration adjustment of the DFE.
Uneven Gloss: Partly
Wax or other substance adhering to certain spots of the fuser belt causes an increase in the rotation
amount of wax at the point of adherence. This results in localized uneven gloss.
[A]: One round of the fuser belt (approx. 278mm)
This is likely to occur if:
Using coated paper of middle thick
Printing a high coverage image
Solution
1. In the “Adjustment Settings for Operators” menu, execute No. 0508-02 " Smooth Fusing Belt:
Uneven Gloss: Short Time".
2. Print the target image (1 sheet). Is the printed image acceptable?
YES: Finish
NO: Repeat executing No. 0508-02 " Smooth Fusing Belt: Uneven Gloss: Short Time"
After taking the above measures, do the color calibration adjustment of the DFE.
Uneven Gloss: Wavy
Uneven gloss waves sometimes occur on the 1st side of paper when printing on thin coated paper in
the duplex mode.
To Next Page
Loading...
