11.Image Quality Problem: Full Page
594
This is likely to occur if:
When printing in a low temperature environment (unprinted area on leading edge due to insufficient
transfer).
When printing in a high temperature environment (unprinted area on leading edge due to excessive
transfer).
When using thin paper (unprinted area on leading edge due to transfer current).
When using thick paper (unprinted area on leading edge due to insufficient transfer pressure).
Solution
This measure only works when the thickness of the paper is equivalent to paper weight 4 or higher.
Do not try this as a measure when using paper with a thickness equivalent to paper weight 3 or
lower, as it may cause paper misfeeding.
Execute commands in the following order: “Adjusting the gap of paper transfer” “Adjusting the
target constant voltage”.
To Next Page
Loading...
