3.Troubleshooting: Paper Delivery Problems
446
the value currently applied.
3. Does the shrink/stretch disappear?
YES: Finished.
NO: Repeat the steps 2 and step 3. If some improvements are found with adjusting the value until -
1.0%, then keep adjusting it. If no improvement can be found, there may be other causes. Restore
the value to the value you took a note in step 1, and then, see other troubleshooting.
If Transfer roller rotates too slow;
1. Take a note of the initial value of 01341-01 (Speed Adjustment: Transfer Timing Roller) in "Custom
Paper Settings".
2. Adjust the value of No. 1341-01 "Speed Adjustment: Transfer Timing Roller" by +0.1% step against
the value currently applied.
3. Does the shrink/stretch disappear?
YES: Finished.
NO: Repeat the steps 2 and 3. If some improvements are found with adjusting the value until 1.0%,
then keep adjusting it. If no improvement can be found, there may be other causes. Restore the
value to the value you took a note in step1, and then, see other troubleshooting.
If Exit roller is dirty;
1. Clean the rollers and guide plates in left drawer.
Cleaning the TIM-Mag Unit Entrance Roller (Cleaning the TIM-Mag Unit Entrance Roller)
Clean the Cooling belt. (Cleaning the Cooling Belt)
Clean the Paper Exit Relay Roller. (Cleaning the Paper Exit Relay Roller)
Clean the Paper Exit Roller. (Cleaning the Paper Exit Roller)
Clean the Paper Exit Inverter Roller.(Cleaning the Paper Exit Inverter Roller)
Clean other guide plates if there are paper dusts.
Solution (2)
If there is no improvement even though cleaning up the exit roller, then adjust the exit motor line speed,
inverter entry speed, and inverter exit speed to the appropriate speeds.
The first we must do is specifying the roller that causes this issue.
Adjustment Item If the Check is YES
Does the issue occur in a normal paper exit?
1341-08 (Speed Adjustment : Switchback: Entrance
Roller) in Custom Paper Settings
Does the issue occur in both inverting (face-
down) and duplex printing?
1341-09 (Speed Adjustment : Exit Roller) in Custom
Paper Settings
Does the issue occur in only inverting (face-
down)?
125 [Switchback Exit Feed Speed Adj] in Custom
Paper Settings
None of the above is applicable.
See Solution (3: Service Only).
To Next Page
Loading...
