Ricoh PRO C7210

4.Troubleshooting: Post-Processing Option
514
Fold type
Adjustment item (for multi-sheet folding)
Adjustment item (for single-sheet folding)
1 sheet Fold
Multi-sheet Fold
Letter
Fold-in
 No. 0709-01 to 10: Letter Fold-in
Position 1: 1 sheet Fold
 No. 0711-01 to 101: Letter Fold-in
Position 2: 1 sheet Fold
 No.0710-01 to 10: Letter Fold-in
Position 1: Multi-sheet Fold
 No.0712-01 to 10:Letter Fold-in
Position 2: Multi-sheet Fold
Letter
Fold-out
 No. 0705-01 to 10: Letter Fold-out
Position 1: 1 sheet Fold
 No. 0707-01 to 10: Letter Fold-out
Position 2: 1 sheet Fold
Values from -4 mm to +4 mm can be
entered, but when a value outside +/-3 mm
is set, the adjustment made is +/-3 mm.
 No.0706-01to 06: Letter Fold-out
Position 1: Multi-sheet Fold
 No.0708-01 to 06: Letter Fold-out
Position 2: Multi-sheet Fold
Values from -4 mm to +4 mm can be
entered, but when a value outside +/-3 mm
is set, the adjustment made is +/-3 mm.
Double
Parallel
 No. 0713-01 to 10: Double Parallel
Fold Position 1
 No. 0714-01 to 10: Double Parallel
Fold Position 2
-
Gate
Fold
 No. 0715-01 to 09: Gate Fold Position
1
 No. 0716-01 to 09: Gate Fold Position
2
 No. 0717-01 to 10: Gate Fold Position
3
-
Folding Deviation
Cause
Depending on paper hardness, folding deviations (skewed folding) may appear.
 A deviation may appear if the edge dimensions of the parts between folds are different.
 For example, in the following illustration, the dimensional difference between the top (L2 [2]) and
bottom (L2 [1]) edges is a deviation.