11.Image Quality Problem: Full Page
657
Cause
When the line speed of the fuser unit is faster than that of the paper exit unit, slack on the paper
gradually increases toward the trailing edge, resulting in a paper crease.
Solution
1. Access the [Adjustment Settings for Operators] menu.
2. Execute No. 0512-01 "Fuser Unit Speed Adjustment".
It takes about 3 minutes.
Matte Paper Scratched During Folding
Refer to "Matte Paper Scratched During Folding".
Insufficient Gloss: Clear Image
Unlike FC mode, the image may appear cloudy if image gloss is low in FCS (clear) mode.
[A]: Normal image
To Next Page
Loading...
