Ricoh PRO C7210

1.SC Codes
362
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Stacker motor (M501) defective
 Connector loose, broken, defective
 Motor overload
 Stack height sensor 1 (S502) defective
 Replace the motor
 Replace the sensor
 Replace the connector
 Reconnect the connector
 Replace the board
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC756-
61
B
Ring Binder: Stacker error
 At the start of stacking, or the end of the operation, even though the unit
signaled stack full (stack up/down sensors went ON together), no stack was
detected.
 When stacking stopped, no stack was detected within 2 sec., even after the
stack full alert. (1st detection triggers a jam, 2nd detection issues this SC
code.)
 Stacker HP sensor (S501) defective
 Stack height sensor 1 (S502) defective
 Stacker document sensor (S504) defective
 Connector, loose, broken, defective
 Replace the motor
 Replace the sensor
 Replace the connector
 Reconnect the connector
 Replace the board
Vacuum Feed LCIT
To recover from the error, check if the SC occurs (feed paper, open/close the doors, Input or Output
check). If the SC occurs again, do the follow steps. After each step, turn the power OFF then ON to
check if the SC occurs again.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC780-
03
B
LCT1: Protection device break error
The fuse blown signal “H (error)” of the fuse on the PSU/PCB in the LCT1 is
detected.
 Connector on the harness between PSU and PCB on LCT1 disconnected
 Harness broken