Ricoh PRO C7210

1.SC Codes
351
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Lower tray lift motor defective
 Upper tray low limit sensor defective
 Connector loose, broken, defective
 Inserter control board defective
 Reconnect the connector.
 Replace the lower tray lift motor.
 Replace the upper tray low limit sensor
 Replace the inserter control board.
 Replace the motor harness.
 Replace the sensor harness.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC754-
82
B
Perfect Binder: Lower tray paper feed position late error
The lower tray did not leave the lower tray paper feed sensor after the lower tray
lift motor had operated for 5 s.
The lower tray did not arrive at the lower tray paper feed sensor after the lower
tray lift motor had operated for 5 s.
 Lower tray lift motor defective
 Lower tray PICK sensor defective
 Connector loose, broken, defective
 Inserter control board defective
Ring Binder
To recover from the error, check if the SC occurs (feed paper, open/close the doors, Input or Output
check). If the SC occurs again, do the follow steps. After each step, turn the power OFF then ON to
check if the SC occurs again.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC756-01
D
Ring Binder: Downstream device communication error
-
 The interface cable connector disconnected/broken
 Board on the ring binder or a downstream device defective
 Replace the interface cable
 Reconnect the connector
 Replace the board on the ring binder or a downstream device