11.Image Quality Problem: Full Page
600
Cause
During paper transfer, toner is compressed at the high-pressure area of paper trailing edges and
becomes an aggregate.
This is likely to occur if:
When using transparent film.
When printing solid images in FCS or FCS Quality mode.
Solution 1 (Moving the image away from the paper edge by at least 5 mm)
Method of separating the image from paper edges by 5mm or more. (Perform one of steps 1 to 3.)
1. In Custom Paper Settings, adjust No. 1101-01"Image Position: Side 1: Across Feed".
2. Adjust the image position.
3. Use paper with extra margin space.
After taking the above measures, do the color calibration adjustment of the DFE.
Solution 2 (Replacing the PTR springs)
White spots are improved by replacing the springs with springs whose transfer pressure is low.
As shown in the figure below, however, it does not completely resolve the problem.
[A]: Standard springs (60 N)
[B]: Countermeasure springs (20 N)
To Next Page
Loading...
