12.Advanced Instructions
662
12. Advanced Instructions
Shortening the Leading/Trailing Edge Margins
Depending on the paper being used, the margins on the copy vary. You can shorten the leading/trailing
edge margins.
1. Register the paper brand in “Custom Paper Settings”.
2. In [Advanced Settings] for the custom paper you are using, adjust the leading/trailing edge margins
with the following SPs.
Decrease the setting value as necessary. (For example, if the value is decreased by 1 mm, the
margin decreases by 1 mm.)
No.1239-01: Margin :BW/FC/FCS/S :Leading Edge
No.1239-02: Margin :BW/FC/FCS/S :Trailing Edge
No.1239-03: Margin :FCS: Leading Edge: Clr/Sp
No.1239-04: Margin : FCS : Trailing Edge: BW/FC/S
No.1239-07: Margin : FCS : Leading Edge: White
No.1239-08: Margin :FCS :Trailing Edge: White
The adjusted margin cannot be applied to masked images that are solid-filled or contain ruled
lines at the leading/trailing edges.
Reducing the leading/trailing edge margin may result in a paper jam on the fusing belt stripper
plate.
To Next Page
Loading...
