4.Troubleshooting: Post-Processing Option
497
Solution
1. Access the "Adjustment Settings for Operators" menu.
2. Check that "0304: Correct Output Paper Curl" (SP1-906-001 to 014) is set to the back curl
correction.
YES: go to the next step.
NO: This might be a different cause. Refer to the other troubleshooting.
3. Check if the back curl correction can be cancelled.
Cancel the back curl correction if paper does not require back curl correction and does not effect
stacking is loaded.
Make a test copy and go to next step if the problem is still occur.
4. Check if the output orientation can be set as face down.
If the output orientation is facing up, set the output orientation facing down. (do the reverse setting)
Make a test copy and go to next step if the problem is still occur.
5. Remove the anti-static brush.
If you have to set the back curl correction, and then use duplex printing (print facing up), remove
the anti-static brush.
If you removed the anti-static brush, the alignment accuracy for stapling might worsen. In
this case, reduce the number of sheets of pre-stacking. It can be set in "No. 0606: Adj Pre
Stack Number" in “Adjustment Settings for Operators” menu (SP6-225-001 to 014).
To Next Page
Loading...
