Ricoh PRO C7210

4.Troubleshooting: Post-Processing Option
513
Solution
The solution depends on whether letter folding is applied to multiple sheets or a single sheet.
When letter folding is applied to multiple sheets
1. Load the paper the other side up.
2. Print the image. Is the problem resolved?
Yes
Finished!
No
Go to the next step.
3. On the machine operation panel: [User Tools] > System Settings > General Features > Set Letter
Fold-in Position for multiple sheets to "4.0 mm". (SP 6-755-101 to 110: FM4 3rds 1 Flap:Fine Adj
1st (size) SEF (Multi Sheet))
4. Print the image. Is the problem resolved?
Yes
Finished!
No
Consult key operators.
When letter folding is applied to a single sheet
 This procedure is applied especially to coated paper.
 To adjust the following settings, pre-register the type of paper in use as a custom paper. For
details, see the “TCRU : Adjustment Item Menu Guide”.
1. In General Features in System Settings, set Letter Fold-in Position for a single sheet to "7 mm".
2. In Advanced Settings for the custom paper in use, select Letter Fold-in Posn 1: Single-sheet Fold.
(SP 6-755-001 to 100: FM4 3rds 1 Flap:Fine Adj 1st Custom Paper 001 to 100)
3. Increase the value by 0.2 mm.
4. Print the image. Is the problem resolved?
Yes
Finished!
No
Repeat Step 2 to 4. If the problem persists even though the setting value is 4 mm larger
than the maximum value, consult key operators.
Poor Folding
Cause
Depending on paper hardness, inaccurate folds may result.
Solution
Change the folding position by adjusting the following items in the "Adjustment Settings for Operators"
menu. For details, see the “TCRU : Adjustment Item Menu Guide”.
Fold type
Adjustment item (for multi-sheet folding)
Adjustment item (for single-sheet folding)
Z-fold
 No. 0701-01 to 09: Z-fold Position 1
 No. 0702-01 to 09: Z-fold Position 2
-
Half Fold
 No. 0703-01 to 19: Half Fold Position:
 No. 0704-01 to 19: Half Fold Position: