3.Troubleshooting: Paper Delivery Problems
416
Solution
Skew Detection Setting
If the skew level of output is not permissible, lowering the SP1-116-001 to 14 (Skew Detection Level)
makes the skew detection level stricter. Note that, however, a skew that exceeds permissible levels is
likely to heighten the frequency of paper jam.
Adjusting the Rotary Gate Position
Overview of adjustment
Using “NBS-180” - “A3" or “DLT”, print a trim image from Tray 2 with setting to “Plain paper, Paper
Thick 2”.
Adjust the gate position using a measurement with the trim image, so that appropriate skew is
obtained.
Do not use any custom papers.
To Next Page
Loading...
