3.Troubleshooting: Paper Delivery Problems
449
Restore the value to the value you took a note in step 1, and then, see other troubleshooting.
If the issue is found in both inverting (face-down) and duplex printing, restore the value to the value
you took a note in step2, and then go to the next step.
5. Adjust values of SP1-008, and SP1-009 by 0.1% (Do not change SP1-007s).
6. Print the target paper.
7. Does the scratch/streak disappear?
YES: Finished.
NO: Repeat the steps 5 through 7. If some improvements are found with adjusting the values until
+1.0%, then keep adjusting them. If no improvement can be found, there may be other causes.
Restore the value to the value you took a note in step 1, and then, see other troubleshooting.
Cleaning the TIM-Mag Unit Entrance Roller
1. Pull out the left drawer.
2. Open the TIM-Mag unit [A].
3. Wipe the TIM-Mag unit entrance drive roller [A] and the TIM-Mag unit entrance idle roller [B] with a
dry cloth.
Wipe the surface of the TIM-Mag unit entrance drive roller [A] while rotating the knob [C]
with pressing the cloth to the roller.
To Next Page
Loading...
