4.Troubleshooting: Post-Processing Option
500
This is likely to occur if:
A high density image is printed in the fold line.
15 or more sheets are bound.
In a low humidity/temperature environment
Solution
Select "Magazine" for the booklet printing method and set the binding margin to 5mm or greater.
Setting by Operation Panel
1. Press [Dup./ Combine/ Series] on Copier screen.
2. Select [Booklet] under “Magazine”.
3. [Edit/Color] > [Margin Adj.], set as follows.
Front Side: Left 5mm
Back Side: Right 5mm
Also can be set with SP6-200-001 to 18: Adj Booklet Staple Position.
Thin, Coated Paper Eject Error (Stapled Sheets)
In the binding process, when thin, coated paper [A] is discharged from the staple tray [B], as the staple
tray that pushes and lifts up the trailing edge of the paper is at a steep angle (55°), it results in a
difference in linear speed between the leading edge and trailing edge, making it buckle; the release
pawl [C] is unable to lift it up, resulting in scratches on the paper and/or jams.
To Next Page
Loading...
