4.Troubleshooting: Post-Processing Option
522
leaving marks on the stack of paper when it is holding it. The top pages of the stack are prone to having
marks left.
Solution
Marks can be prevented by putting scrap paper in between [A].
Prevent Loosening of Screws to the Cart's Handle
There have been cases of screws [A] to the handle of the cart loosening.
Cause
The torque on the mounting bolt of the handle on the bottom of the cart is too low, so when the cart is
loaded with paper and it is pushed/pulled repeatedly, the mounting bolt may get loose.
This is likely to occur if:
This is prone to happening if the torque on the mounting bolt of the handle is less than 18Nm.
Solution
If the cart's handle starts to rattle, or if the paper holder fails to be effective because of loosening, re-
To Next Page
Loading...
